Cutting Fret Slots - The Hard Way

fret slot depths again after creating the fretboard radius, this is easier done after the neck is

Cutting Fret Slots - The Hard Way Slots are normally cut to 023 for most fret wire used today Tang measurement varies a bit dependent upon size but it's usually around 116

fret slot depths again after creating the fretboard radius, this is easier done after the neck is

win slot Most fret slotting profiles are a standard ″ width at the tang, our 18″ shank Fret Router bit works well for cutting 023″ fret slots It also can be

The guides can be adjusted to match the blade precisely You can quickly slot any board up to 3 wide The position of the fret slots can be measured out

fret slot depth fret slot depths again after creating the fretboard radius, this is easier done after the neck is

I found this in about 11 seconds using Google mm - mm = mm minimum slot depth